Set Up the Campus-REX System

2To change the Transceiver Mode, type then press ENTER . The Transceiver Mode changes to the next available setting.

Continue with the following steps if the Transceiver Mode is set to Master. If you set the Transceiver Mode to Slave, you cannot configure the remaining options on this menu. These settings will be acquired from the master unit when the HDSL link is established.

Dec 9, 1999

ADC DSL SYSTEMS

INC., CAMPUS RS, Version x.xx

13:19:32

Local Unit ID:

Campus-REX Unit #34

Local I/F:

REX

Remote Unit ID: Campus-REX Unit #12

Remote I/F: REX

Circuit

ID:

Network Extension Circuit 5001

 

 

 

AUTOSYNC MODE HDSL PARAMETERS

 

1)

HDSL Operating Mode:

Autosync

(Standard, Extended, Autosync)

2)

Transceiver Mode:

Master

(Master, Slave)

 

3)

HDSL Loop Mode:

2 Loops

(1 Loop, 2 Loops)*

4)

HDSL Rate:

256

 

 

*Note:

1 Loop = single loop, full duplex

2 Loops = two loops, full duplex

Remote Unit must be set as Autosync, Slave.

Changes will not be effective until this menu is exited!

(R)eturn (M)ain Menu

ENTER CHOICE>

3To change the HDSL Loop Mode, type 3 then press ENTER . The HDSL Loop Mode changes to the next available setting.

4Type 4 then press ENTER . The Select HDSL High Rate (if the HDSL Loop Mode is set to 1 Loop) or Select HDSL Low Rate (if the HDSL Loop Mode is set to 2 Loops) menu displays.

Campus-REX RS Interface Card User Manual

3-17