Set Up the Campus-REX System

5Type 1 0 then press ENTER . The terminal prompts you to enter the Destination address for the second routing table entry.

6Repeat steps 2 through 4. The terminal displays the Bridge/Router Configuration menu with the first two entries of the routing table filled in.

7Type 1 1 then press ENTER . The terminal prompts you to enter the Destination address for the third routing table entry.

8Repeat steps 2 through 4. The terminal displays the Bridge/Router Configuration menu with the completed routing table.

9Type R then press ENTER

10Type 3 then press ENTER NVRAM.

to return to the Data Port Settings menu.

to write the new bridge configuration to

11If you are done making configuration changes, type 4 then press ENTER to reset the Campus-REX and enable the changes. If you plan to continue making configuration changes, wait until you have finished before resetting the system.

Make sure you reset the interface card when you have finished changing bridge/router configuration options. The changes do not take effect until the system is reset.

3-28

Campus-REX RS Interface Card User Manual