Set Up the Campus-REX System

Using the LCD

To set the Timing Source from the LCD:

1Press Escape until Campus RS I/F: REX displays.

2Press Next twice, until DATA PORT CONFIG & STATUS displays, then press Enter. The LCD displays CONFIGURE REX SETTINGS.

3Press Enter. The LCD displays REX MODE.

4Press Next until TIMING SOURCE displays, then press Enter. The LCD displays the current Timing Source setting.

5Press Next until the desired Timing Source setting displays, then press Enter. The LCD displays the new Timing Source setting.

Using an ASCII Terminal

To set the Timing Source from an ASCII terminal:

1Connect the ASCII terminal and log on to the Main Menu. See “Set Up an ASCII Terminal” on page 3-2for instructions.

2From the Main Menu, type 2 then press ENTER . The Data Port Settings menu displays.

Dec 9, 1999

ADC DSL SYSTEMS INC.,

CAMPUS RS, Version x.xx

13:16:44

Local Unit ID:

 

Campus-REX Unit #34

Local I/F:

REX

Remote Unit ID:

Campus-REX Unit #12

Remote I/F: REX

Circuit ID:

 

Network Extension Circuit 5001

 

 

 

 

DATA PORT SETTINGS

 

MAC ADDRESS:

00:20:A7:21:2F:6B

 

10BASE-T STATUS: Up

1)BRIDGE/ROUTER CONFIGURATION

2)SNMP CONFIGURATION

3)WRITE NVRAM

4)RESET INTERFACE CARD

WARNING: NVRAM must be written and interface card reset for any configuration changes to take effect.

(R)eturn

ENTER CHOICE>

3-30

Campus-REX RS Interface Card User Manual