Introduction

Status LEDs

Figure 1-3: Front Panel LEDs

Rear Panel Telemetry LEDs

The telemetry LEDs are located on the back of the probe. (See Figure 1-4.)

10Base-T/100Base-TX Telemetry Interface Status LEDs

On the back of the probe, there are LEDs associated specifically with each interface and a Power LED. The 10Base-T/100Base-TX telemetry interface has LEDs for Activity, Link and Collision.

Link. This green LED is turned on when the probe is attached to a 10Base-T/ 100Base-TX network.

Collision. This yellow LED is turned on when the probe detects collisions on the network.

11

Page 31
Image 31
Agilent Technologies J3916A manual Rear Panel Telemetry LEDs, 10Base-T/100Base-TX Telemetry Interface Status LEDs