Agilent Technologies J3916A manual Port

		Local Terminal Configuration
		Using the Main Menu
	Port	Press 1 and then press 1 again to display the current Ethernet
		port configuration parameters and current settings.
NOTE	If the optional Token-Ring telemetry interface is not installed, the probe will not
	allow you to change the Fast Ethernet interface’s port type from telemetry.
	If the Token-Ring telemetry interface is installed, you can configure either the
	Fast Ethernet interface or the Token-Ring interface as the telemetry interface. The
	Fast Ethernet interface comes from the factory configured as Telemetry and the
	Token-Ring interface comes configured as Monitor/Transmit and is disabled.
	“Disabled” in this case means that the interface does not function at all, not as a
	Telemetry port nor as a Monitor/Transmit port. If you configure the Token-Ring
	interface as Telemetry, the Fast Ethernet interface automatically becomes
	configured as Monitor/Transmit and is disabled.
	Port Type	The Fast Ethernet interface is always a Telemetry port. The
		telemetry port does not maintain network statistics for the

Fast Ethernet interface. The telemetry interface only allows the retrieval of WAN network statistics. Port 1 is the Fast Ethernet interface and it is the telemetry port by default. If the Token-Ring interface is also installed, you can select either the Fast Ethernet or the Token-Ring interface (but not both) as the telemetry port. Refer to “Token-Ring Telemetry Interface Configuration” on page 29 for information on configuring the Token-Ring interface. The probe must be configured with exactly one telemetry port.

27