Exiting the Main Menu and Restarting the Probe
1.On the Main menu, Press 7 to execute a warm start or press 8 to execute a cold start.
A cold start is required if you change the IP Address, Default Gateway, or Subnet Mask. For either menu choice, the probe exits the Main Menu and restarts normal operations.
2.If you are performing the initial probe configuration, prepare the probe for installation by disconnecting the power cord. You will not lose your initial configuration information.
NOTE | A warm start resets all data collected by the probe. A cold start resets all data |
| collected by the probe and also resets any |
| history studies, filters, and alarms to their default values. Refer to “Probe |
| Operation” on page 89 for more information on what is reset by warm and cold |
| starts. |
| After the probe restarts (boots), it operates normally using the new configuration |
| |
| information. The warm start or cold start occurs immediately and there is no |
| visual indication of when it finishes. |
40
