Collecting Audit Information

This feature allows the owner to retrieve audit information stored in the washer by pressing a sequence of pads on the control. For an explanation of the audit options available, see the Audit Options List on this page.

How to Enter Audit Feature

1.Control must be in Manual Mode to start. Refer to Entering the Manual Mode.

2.Press the DELICATES (+) or the COLD (-) keypad until “AUdT” appears. Refer to Figure 202.

C823I

Figure 202

3. Press the START keypad. “CyCL” will appear.

If the procedure did not work, the control will return to the ready mode. Refer to Figure 2.

How to Read Audit Data

1.Use the DELICATES (+) or the COLD (-) keypad to scroll through various options until the desired option is displayed in the VFD. Refer to the Audit Options List, Table 11, for an explanation of the audit options available. Refer to Figure 203.

1

3 2

C860I

1Press this pad (+) to scroll forward or increase a value

2Press this pad (enter) to choose a selected value or option

3Press this pad (-) to scroll back or decrease a value

 

 

Audit Options List

 

 

 

#

VFD

Description

Display

 

 

 

 

 

1

“CyCL”

Total # of machine cycles

 

 

 

2

“COI1”

Total # of coins #1

 

 

 

3

“COI2”

Total # of coins #2

 

 

 

4

“PLSE”

Total # of Start Pulses

 

 

 

5

“CArd”

Smart Card Reader Firm Ware Version #

 

 

 

 

 

Table 11

2.Once the desired option appears in the VFD, press the START (enter) keypad once to start the audit count. At this point, the display will show the first four-digit segment of the audit value. Press the START (enter) keypad again to view the last four digits of the number.

NOTE: The VFD can display up to 4 digits at one time. All audit counts are separated into two 4-digit segments. Each time the START (enter) keypad is pressed in step 2, the VFD will show the next four- digit segment in the audit value.

For Example: In the Total Number of Coins #1 option with “COI1” displayed in the VFD, the audit has counted 10,009 coins. Pressing the START (enter) keypad one time will show “_ _ _ 1” to represent ten thousand. Pressing the START (enter) keypad a second time will display “0009” meaning nine. The total equals “00010009” or 10,009.

3.Press the START (enter) keypad again. The control will go to the next audit option in the Audit Options List.

4.To select other audit options, repeat steps 1 – 4.

How to Exit Audit Feature

1.Be sure the control shows an audit option, not a value.

2.While pressing and holding the NORMAL keypad with one hand, press the PERM PRESS keypad with the other hand. The control will return to the ready mode. Refer to Figure 2.

Figure 203

210140

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

109