Programming NetMaster

25. Power Fail Reset “+025”

This option allows the owner to set the amount of time NetMaster will store active cycle information in the event of a power failure. The default setting for Power Fail Reset is OFF. If Power Fail Reset is turned OFF, the cycle will be saved for up to six years.

How to Program Power Fail Reset

1.Control must be in Manual Mode. Refer to Entering the Manual Mode.

2.Press the DELICATES (+) or the COLD (-) keypad until “PrOg” appears in the VFD. Press the START (enter) keypad and “+001” will appear in the VFD.

C762I

Figure 105

3.Press the DELICATES (+) or the COLD (-) keypad to scroll through the programmable options until “+025” appears in the VFD. Refer to Figure 106.

C787I

Figure 106

4.When “+025” appears in the VFD, press the START (enter) keypad. A number will appear in the VFD. This number corresponds to the current Power Fail Reset setting.

5.Press the DELICATES (+) or the COLD (-) keypad to increase or decrease the current number to the desired number selected from Table 4. Refer to Figure 107.

1

3 2

C860I

1Press this pad (+) to scroll forward or increase a value

2Press this pad (enter) to choose a selected value or option

3Press this pad (-) to scroll back or decrease a value

Figure 107

6.Press the START (enter) keypad when the correct number appears in the VFD. The next option, “+026”, will appear in the VFD.

NOTE: To program “+026” (Set Real-Time Clock Minutes), refer to option 26. To program other options, refer to the appropriate section.

How to Exit Programming Feature

1.Be sure the control shows a programmable option, not a value.

2.While pressing and holding the NORMAL keypad with one hand, press the PERM PRESS keypad with the other hand. The control will revert back to the ready mode. Refer to Figure 2.

68

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

210140