Programming NetMaster

48. Lucky Option “+048”

This option allows the owner to program the machine to provide a free vend cycle to customers after a certain number of machine cycles have occurred.

For coin models, “FrEE” will be displayed five minutes after the completion of the programmed number of cycles has occurred. The cycle can then be started by pressing the START (enter) pad.

For card models, when a card is inserted, the VFD will display “bAL” followed by the card balance. When the user presses the START pad, a zero vend will be deducted from the card. The VFD will display “WAIT”. The VFD will then display “FrEE” for five seconds and then the cycle time will be displayed. When the card is removed, the VFD will flash the remaining balance for three seconds and will then revert back to the cycle time.

How to Program Lucky Option

1.Control must be in Manual Mode. Refer to Entering the Manual Mode.

2.Press the DELICATES (+) or the COLD (-) keypad until “PrOg” appears in the VFD. Press the START (enter) keypad and “+001” will appear in the VFD.

C762I

Figure 174

3.Press the DELICATES (+) or the COLD (-) keypad to scroll through the programmable options until “+048” appears in the VFD. Refer to Figure 175.

C809I

Figure 175

4.When “+048” appears in the VFD, press the START (enter) keypad. A number will appear in

the VFD. This number corresponds to the current Lucky Option Programming Value.

5.Locate the desired number in the first column of Table 7 below.

“+048”

Lucky Option

Lucky Cycle

Number of

Value

ON/OFF

Cycles

 

 

 

1 – 127

OFF

1 – 127

 

 

 

129

ON

1

 

 

 

130

ON

2

 

 

 

131 – 255

ON

3 – 127

 

 

 

Table 7

6.Press the DELICATES (+) or the COLD (-) keypad to increase or decrease the current number until correct. Refer to Figure 176.

1

3 2

C860I

1Press this pad (+) to scroll forward or increase a value

2Press this pad (enter) to choose a selected value or option

3Press this pad (-) to scroll back or decrease a value

Figure 176

7.Press the START (enter) keypad when the correct number appears in the VFD. The next option, “+049”, will appear in the VFD.

NOTE: To program “+049” (Special Cycle Option), refer to option 49. To program other options, refer to the appropriate section.

How to Exit Programming Feature

1.Be sure the control shows a programmable option, not a value.

2.While pressing and holding the NORMAL keypad with one hand, press the PERM PRESS keypad with the other hand. The control will revert back to the ready mode. Refer to Figure 2.

96

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

210140