Programming NetMaster

46.Control Configuration Data #1 “+046”

This option allows the owner to turn ON or turn OFF preprogrammed capabilities within NetMaster.

How to Program the Control Configuration Data #1

1.Control must be in Manual Mode. Refer to Entering the Manual Mode.

2.Press the DELICATES (+) or the COLD (-) keypad until “PrOg” appears in the VFD. Press the START (enter) keypad and “+001” will appear in the VFD.

C762I

Figure 168

3.Press the DELICATES (+) or the COLD (-) keypad to scroll through the programmable options until “+046” appears in the VFD. Refer to Figure 169.

C807I

Figure 169

4.When “+046” appears in the VFD, press the START (enter) keypad. A number will appear in the VFD. This number corresponds to the current Control Configuration Data #1 Value.

5.Press the DELICATES (+) or the COLD (-) keypad to increase or decrease the current number to the desired number selected from Table 5. Refer to Figure 170.

1

3 2

C860I

1Press this pad (+) to scroll forward or increase a value

2Press this pad (enter) to choose a selected value or option

3Press this pad (-) to scroll back or decrease a value

Figure 170

6.Press the START (enter) keypad when the correct number appears in the VFD. The next option, “+047”, will appear in the VFD.

NOTE: To program “+047” (Control Configuration Data #3), refer to option 47. To program other options, refer to the appropriate section.

How to Exit Programming Feature

1.Be sure the control shows a programmable option, not a value.

2.While pressing and holding the NORMAL keypad with one hand, press the PERM PRESS keypad with the other hand. The control will revert back to the ready mode. Refer to Figure 2.

90

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

210140