Washer Operation

Start Up

When power is applied to the washer, the control will display INSERT COINS/CARD, the decimal point, and the vend price. The INSERT COINS/CARD light will remain lit until the vend price has been satisfied. The default cycle setting is PERM PRESS, the default wash water fill temperature is WARM, and the default rinse water temperature is COLD. The LEDs will be lit on PERM PRESS and WARM at the start of the cycle. Refer to Figure 2. These default settings are owner programmable. Refer to Programming NetMaster.

Ready Mode

C833I

Figure 2

To start the cycle, the user must press the START keypad.

The user will be able to select a different cycle or wash water temperature by pressing a cycle pad when the machine is in the ready mode or in the first fill cycle. If not enough vend is entered to satisfy the vend price, the control will display the remaining vend price needed to start the cycle. If the first fill was interrupted to change the temperature (which requires more money), and the vend price is not satisfied within 1 minute, the washer control will go back to the first selection and the cycle will restart. After the first fill, all key presses will be ignored, allowing the washer to go through the complete cycle.

When a cycle is complete, the control will display “:00” until the lid is opened, a key is pressed, or a coin/card is entered. When one of these three options occur, the display will revert back to the ready mode. Refer to Figure 2.

Cycle Sequence

Upon the start of a cycle, NetMaster will display the total cycle time. The appropriate LEDs will light while the machine passes through different cycle steps. Any

coin entered after the first fill cycle will be added to the total coin counter, but the user will not be able to change cycles or water temperature.

Opening the Washer Lid

If the washer lid is opened anytime except the last three minutes of a cycle, the VFD will display “LId” and the timer will stop. Once the lid is closed, the cycle will restart from the point of interruption. If the lid is opened in the final three minutes of the final spin cycle, the timer will continue to count down to the end of the cycle. The cycle operation will stop and the VFD will display “LId”. When the timer reaches 0 minutes, the control will return to the “Ready” mode. Refer to Figure 2.

Signals

There are four options when a signal can be used during the washer operation. These four options are listed below:

1.End of Cycle Signal

By default, this signal is turned off. If turned on, the signal sounds for three (3) seconds at the end of a cycle.

2.Signal On Keypad Depression

By default, this signal is turned on and sounds for a quarter of a second each time a keypad is pressed.

3.Signal On Coin Drop/Card Insertion

By default, this signal is turned on and will sound for a quarter of a second each time a coin or card is entered.

4.Signal for Card Removal (Card Models Only) By default, this signal is turned on and will sound one second on and one second off when the REMOVE CARD LED is flashing.

NOTE: Refer to Programming NetMaster to program signal options.Changing Cycles

Cycles and wash temperatures can be changed anytime during the first fill cycle. After the first fill cycle, all key presses are ignored.

Selecting a higher priced wash temperature will stop the first fill cycle, and INSERT COINS/CARD will flash one

(1)second on and one (1) second off until the vend price has been satisfied. After the vend price has been satisfied, the cycle will restart with the new wash temperature. If the vend price is not satisfied within 1 minute, the washer control will go back to the previously set wash temperature.

210140

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

15