VFD Display Identification

Light Emitting Diodes (LEDs) (Refer to Figure 1)

LIGHT EMITTING DIODES (LEDs) are used to indicate the chosen cycle, wash temperature and cycle status. See below for information on each LED.

CYCLE LED (NORMAL, PERM PRESS orDELICATES)

CYCLE LED will remain lit the entire cycle.

WASH TEMP LED (HOT, WARM or COLD)

WASH TEMP LED will remain on until the end of the cycle or will change to a rinse temperature if programmed to do so.

WASH LED

WASH LED is lit at the beginning of a Wash cycle and will remain lit until the wash cycle is complete.

RINSE LED

RINSE LED is lit at the beginning of the Rinse or Extra Rinse cycle and will remain lit until the cycle is complete.

SPIN LED

SPIN LED is lit for all Spin cycles.

INSERT COINS/CARD LED

INSERT COINS/CARD LED prompts the user for coins or a card to satisfy the vend price. Four digits and decimal point show the vend price remaining to be satisfied. The vend price displayed will decrease with each coin inserted. If a new wash temp is selected during the first fill of the wash cycle and it requires additional vend, the INSERT COINS/CARD light will flash one (1) second on and one (1) second off, and the display will show the vend price remaining to be satisfied.

REMOVE CARD LED (Card Models Only)

REMOVE CARD LED flashes one second on and one second off after the START pad has been pressed and the vend has been deducted from the card. It will also flash when a card is inserted and no vend amount is required.

Four 7-Segment Digits

The 7-SEGMENT DIGITS are used to display the time remaining in a cycle, vend price, error messages and descriptive codes. When displaying the time remaining the colon will flash, and when displaying the vend price the decimal point may be lit. During diagnostic testing or manual programming of the control, these digits will display descriptive codes and values (as described in Entering the Manual Mode).

210140

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

13