NetMaster Special Features

Programming NetMaster

NetMaster allows the washer owner to program the control with the use of the keypad. Audit, diagnostic, cycle and vend information may be programmed and retrieved by pressing combinations of the Select Cycle and Select Wash Temp pads.

For details on programming cycle and vend information, refer to Programming NetMaster.

Collecting Audit Information

The control will store audit information in its memory that can be retrieved by pressing various combinations of Select Cycle and Select Wash Temp pads. NetMaster will record coins entered, total wash cycles, and total start pulses.

For more information on the audit features, refer to Collecting Audit Information.

NOTE: Additional audit information is retrievable with the Micro-Wand IIIE, the Card Reader or the Network. Refer to the appropriate instruction manual.

Testing Machine and NetMaster Functions

Special programmable diagnostic features built into NetMaster allow the owner to run specific diagnostic tests. By opening and closing the service door and then pressing various sequences of Select Cycle and Select Wash Temp pads, the owner may perform the following tests:

●Control Software Version Number

●Service Door Opening Test

●Coin Vault Opening Test

●Coin Drop #1 Input Test

●Coin Drop #2 Input Test

●Lid Switch Input Test

●Pressure Switch Opening Test

●Show Fill Time Test

●Show Drain Time Test

●Start Pulse Test

●Configuration Display Tests

For detailed information on running diagnostic tests, refer to Testing Machine and NetMaster Functions.

Sales Floor Feature

NetMaster washer has a built-in sales floor routine used to display all LED lights and the four digits with the colon and decimal point. This function is designed to show potential customers the high-tech features of NetMaster and to verify that all segments of the VFD work.

For detailed information on using the Sales Floor feature, refer to Sales Floor Feature.

Rapid Advance Feature

This feature allows the user to quickly advance through active cycles or advance into a cycle from the ready mode. This feature is useful when tests must be performed immediately on a washer currently in an active cycle. In this case, the user can quickly advance through the cycles to the ready mode. At this point, the user can perform the required tests and then return the washer to the point it was interrupted.

For detailed information on using the Rapid Advance feature, refer to Rapid Advance Feature.

Clearing the NetMaster Vend Feature

This feature allows the user to return NetMaster back to the ready mode if coins have been entered but the full vend price has not yet been satisfied. Refer to Figure 2.

For more information on using the Clear Vend feature, refer to Clear Vend Feature.

Communications Mode

This feature allows the washer control to communicate with the Micro-Wand IIIE, the Card Reader or the Network. This allows the washer control to be programmed and have its data read without using the keypad.

For more detailed information on using the Communications Mode feature, refer to Communications Mode.

Coin Drop

The control will accept pulses from a single or dual coin drop to satisfy vend price. Each coin drop will have the ability to start or run a cycle.

210140

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

17