Programming NetMaster

24.Default Cycle/Temperature “+024”

This option allows the owner to set the default cycle and temperature the machine will enter when in the ready mode. When programming the default cycle, refer to Table 3 on the following page.

How to Program Default Cycle/Temperature

1.Control must be in Manual Mode. Refer to Entering the Manual Mode.

2.Press the DELICATES (+) or the COLD (-) keypad until “PrOg” appears in the VFD. Press the START (enter) keypad and “+001” will appear in the VFD.

C762I

Figure 102

3.Press the DELICATES (+) or the COLD (-) keypad to scroll through the programmable options until “+024” appears in the VFD. Refer to Figure 103.

C788I

Figure 103

4.When “+024” appears in the VFD, press the START (enter) keypad. A number will appear in the VFD. This number corresponds to the current default cycle value.

5.Press the DELICATES (+) or the COLD (-) keypad to increase or decrease the current number to the desired number selected from Table 3 on the following page. Refer to Figure 104.

1

3 2

C860I

1Press this pad (+) to scroll forward or increase a value

2Press this pad (enter) to choose a selected value or option

3Press this pad (-) to scroll back or decrease a value

Figure 104

6.Press the START (enter) keypad when the correct number appears in the VFD. The next option, “+025”, will appear in the VFD.

NOTE: To program “+025” (Power Fail Reset), refer to option 25. To program other options, refer to the appropriate section.

How to Exit Programming Feature

1.Be sure the control shows a programmable option, not a value.

2.While pressing and holding the NORMAL keypad with one hand, press the PERM PRESS keypad with the other hand. The control will revert back to the ready mode. Refer to Figure 2.

66

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

210140