5In the panel that appears, you can change settings if you need to.

For example, if you know that the printer will never receive a NetWare message over the network, you can turn off the NetWare interface and stop the printer from sending out unnecessary NetWare packets.

To change the settings for these ports, use the pop-up menus.

To see the original settings, click Default. Then, if you want to reset the ports to the original settings, click Send.

You cannot change the

LocalTalk setting.

You can leave these ports on (the default) or turn them off.

If you use Apple Print Monitor for Windows and the PostScript LaserWriter Driver 3.0 together over the parallel port, make sure Data is set to AutoSelect.

6To send the changes to the printer, click Send.

This implements the new settings. You can alert users about the changes.

IMPORTANT As long as you leave the printer’s configuration switch in the right-hand position, the printer uses the settings in this panel. If for any reason you need to return to the original, default settings, click the Default button. If you cannot use the Apple Printer Utility to reset the ports, flip the configuration switch to the left-hand position. Then restart the printer and return the switch to the right-hand position.

Setting Up the Printer for Macintosh Users

71

Page 96
Image 96
Apple 12/600PS manual Panel that appears, you can change settings if you need to, You cannot change LocalTalk setting