Baldor VS1MD instruction manual

1 = Operation stops when cooling fan malfunctions

When cooling fan fault occurs, message is displayed on the LED and operation is stopped. If t32 and/or t33 is set to 17 (Fault Output), fault message is displayed.

H81 -

H90

Second Motor Parameters

Range:	See below
Default:	See below
Access	Configurable
See Also:	t1-t8

These parameters activate when a selected terminal is ON and one of the t1 thru t8 terminals is set for 12 (2nd Motor Select).

Param.	Description	Range			Factory Default	Adj. run
H81	Accel Time	0	~ 60000 Sec		1.0
H82	Decel Time	0	~ 60000 Sec		5.0
H83	Base Freq	30		~ 400 Hz	60.0	-
H84	V/F Pattern	0	~ 2		0	-
H85	FX Torque Boost	0	~ 15 %		5	-
H86	RX Torque Boost	0	~ 15 %		5	-
H87	Stall Level	30		~ 150 %	150	-
H88	1 Min Overload Level	50		~ 200 %	150
H89	Continuous Overload Level	50		~ 150 %	100	￿
H90	Motor Rated Current	0.1 ~ 50 Amps			26.3	-

Use these settings when an inverter operates two motors connected to two

different types of loads. 2nd motor operation does not drive two motors at the same time. When first selected motor operation is stopped, select a terminal for the second motor and define H81 thru H90 to run the second motor.

VS1MD

M 1

M 2

P8

Sets the V/F pattern for the second motor.

7-56 VS1MD AC Drive User Manual