Baldor VS1MD instruction manual Sets the off delay timer for the digital output

22 = Exchange between second source and drive: When the defined input is turned ON, the values set in drv2 and Frq2 are used for control and reference to the drive. Settings for drv2 and Frq2 can not be changed while the digital input is closed. During the change over from the Main Source to the 2nd source, the drive will stop if the control source differs. To restart the drive, a new run command must be given.

Digital/Relay Output On/Off Delay

A timer function has been implemented by adding four new software parameters. Two are for the On Delay and two for the Off Delay timer to the digital outputs of the VS1MD drive. Setting a value of greater than zero will begin the On, Off or both timers when the condition set in t32 and t33 for the digital outputs is met.

In the case of the On delay timer, the actual output will not change state until the time value set in t50 to t51 is met. The Condition set in t32 to t33 must be active when the timer is reached for the output state to change.

In the case of the Off delay timer, once the output state is on, it will delay turning off after the Off delay value is reached on t52 to t53. When the Off delay time is reached, the condition set in t32 to t33 must still be off.

t50	Digital Output (MO) On Delay
t51	Relay Output (3A - 3C) On Delay
	Range:	0 to 3,600 Seconds
	Default:	0
	Access:	Configurable
	See Also:	t32 and t33
	Sets the on delay timer for the digital output.
t52	Digital Output (MO) Off Delay
t53	Relay Output (3A - 3C) Off Delay
	Range:	0 to 3,600 Seconds
	Default:	0
	Access:	Configurable
	See Also:	t32 and t33

Sets the off delay timer for the digital output.

MO or Relay State

Output

MO or Relay State

Output

On Delay Tme On Delay Time

Off Delay Time Off Delay Time

Errata Sheet for the VS1MD Drive Installation & Operating Manual