Baldor instruction manual 6.2 VS1MD-NM1D Preparation

Step 3. Install the two screws removed from the ground connection bar during preparation Step 3 such that they are inserted through the two holes in the conduit kit prior to engaging the ground connection bar. Install the screw provded with the conduit kit through the hole in the bottom right corner of the drive into the top right tab of the conduit kit.

Step 4. After connecting conduits and making control and power connections, replace the drive cover.

Step 5. Replace the conduit kit cover utilizing the two screws removed in preparation Step 4.

B.2.6.2 VS1MD-NM1D

Preparation:

Step 1. Remove input power from drive and wait 10 minutes before proceeding.

WARNING: Do not touch any circuit board, power device or electrical

!connection before you first ensure that power has been disconnected and ! there is no high voltage present from this equipment or other equipment to

which it is connected. Electrical shock can cause serious or fatal injury. Only qualified personnel should attempt the start-up procedure or troubleshoot this equipment.

WARNING: Do not remove cover for at least ten (10) minutes after AC

!power is disconnected to allow capacitors to discharge. Dangerous ! voltages are present inside the equipment. Electrical shock can cause

serious or fatal injury.

Step 2. Remove cover from drive, exposing terminal strips.

Step 3. Remove two screws holding wire gland plate to drive. Retain screws. Remove and discard wire gland plate.

Options & Kits B-7