105
INTRODUCTION NAVIGATION RADIO MODE CD MODE INDEXSETUPCD CHANGER
ENGLISH
DEUTSCH
DEUTSCH
DEUTSCH
✔You will be asked to drive the route.
7Use the / buttons on the rocker switch 7 to select START.
8Carry out the steps as instructed by the system.
Carrying out the system test
You have the option of carrying out a system test. The system checks the GPS
antenna and whether the reversing signal and the vehicle ignition are correctly
connected to the system.
1Select SYSTEM TEST menu item in the INSTALLATION setup menu.
2Press the OK button 8.
3Choose between SENSOR TEST, INTERNAL TEST and CALIBRAT. DATA.
✔The displays containing the corresponding test results are shown.
Activating / deactivating the code LED
You can activate the code LED to indicate that your TravelPilot is theft protec-
ted. The code LED is located on the ON button 2. If CODE-LED is activated in
the setup menu, the ON button 2 flashes when the unit and vehicle ignition are
turned off.
To activate / deactivate the code LED,
1select the CODE-LED menu item in the setup menu and
2keep pressing the OK button 8 until the required ON or OFF setting is
displayed.
The code LED is activated / deactivated
SETTINGS
INSTALL
DEFAULT SET.
KEYCARD
FM-SEEK SENS
CODE-LED ON
INSTALLATION
SYSTEM TEST
CALIBRATION
GPS STATUS