Error Message

Cause

Action

Print Unable XX

The machine has a mechanical

Do one of the following:

(XX=Error Code)

problem.

„ Disconnect the machine from the power

 

 

 

for several minutes, then reconnect it.

 

 

(The machine can be turned off for up to

 

 

60 hours without losing faxes stored in

 

 

the memory. See Transferring your faxes

 

 

or Fax Journal report on page 148.)

 

 

„ If the problem continues, call your

 

 

Brother dealer.

 

 

 

Print Unable 1A

One of the issues that can cause

Turn the power switch off and fully open the

 

this error is that condensation

top cover. Leave the machine off and open

 

may form inside the machine after

for 30 minutes to remove any condensation

 

a room temperature change.

from inside the machine, then close the top

 

 

cover and turn the machine on again. If this

 

 

does not clear the error, call your dealer or a

 

 

Brother Customer Service.

 

 

 

Protected Device

The protect switch of the USB

Turn off the protect switch of the USB Flash

(MFC-9320CW only)

Flash memory drive is on.

memory drive.

 

 

 

 

 

Registration

Registration failed.

Press Mono Start or Colour Start and try

 

 

again.

 

 

Do one of the following:

 

 

„ Turn off the machine’s power switch.

 

 

Wait a few seconds, then turn it on again.

 

 

„ Try Manual Registration, Menu, 4, 7.

 

 

(See Manual Registration on page 165.)

 

 

„ Put in a new belt unit. (See Replacing the

 

 

belt unit on page 177.)

 

 

„ If the problem continues, call your

 

 

Brother dealer.

 

 

 

Rename the File

There is already a file on the USB

Change the file name of the file on the USB

(MFC-9320CW only)

Flash memory drive with the

Flash memory drive or the file you are trying

same name as the file you are

to save.

 

 

trying to save.

 

 

 

 

Replace Belt

It is time to replace the belt unit.

Replace the belt unit. (See Replacing the

 

 

belt unit on page 177.)

Replace Drums

It is time to replace the drum

Replace the drum units.

 

units.

(See Replacing the drum units on page 174.)

 

 

 

 

 

 

The drum unit counter was not

Reset the drum unit counter.

 

reset when a new drum was

(See Resetting the drum counter

 

installed.

 

on page 177.)

 

 

 

 

 

Replace Drum(X) 1

It is time to replace the drum unit

Replace the drum unit for the colour

 

for the indicated colour.

indicated on the LCD.

 

 

(See Replacing the drum units on page 174.)

 

 

 

146