96

C H A P T E R E L E V E N

 

If you wish to install MFL Unimessage Pro, repeat Steps 3 to 5, then select STEP 2 to install MFL Unimessage Pro. Again following the onscreen prompts and re-booting your PC when instructed to do so.

7When installation is complete remove the CD-ROM from the drive.

*You can make floppy disks to install the software on another PC without a CD-ROM Drive. When making the floppy disks, label the first one disk 1, the second disk 2 and so on until the program completes. To install from floppy insert disk 1 in your floppy disk drive and type A:\SETUP.EXE” where A is your floppy disk drive [see step 3 for more details].

Installing the Maintenance Utility on MS-DOS®

How to Use the MFC withYour DOS

Application Software

Before working with your application software that runs on DOS, check that the machine’s name appears in the printer selection of your application software. If the machine is not listed, you must select the printer that corresponds to HP LaserJet IIP’s emulations.

The following table shows combinations of printer drivers and emulation mode. To get the most out of this machine, you should install an HP printer driver in your application software.

Printer driver supported in

Emulation mode to be selected with

your application software

the remote printer console program

 

 

HP LaserJet IIP™

HP LaserJet IIP emulation mode

HP LaserJet II™

Auto emulation selection

 

 

Be sure to choose the proper printer driver in your application software.

Be sure the printing resolution is set to 300 dpi in your DOS application software.

Page 104
Image 104
Brother MFC-9870 manual Installing the Maintenance Utility on MS-DOS, How to Use the MFC withYour DOS Application Software