Cabletron Systems 7C03, 7C04-R manual Using the Mouse in a Hub View Module

Using the 7C0x SmartSwitch Hub View

Clicking the Device button displays the Device menu, Figure 2-2.

Figure 2-2. 7C0x SmartSwitch Hub View Device Menu

The Device menu lets you perform the following:

•Open the Device Configuration window

•Launch the Global Find MAC Address tool (described in the SPMA Tools Guide)

•Open the Polling Intervals window

Note that the Device menu provides access to only a few of the applications which are available to the 7C0x SmartSwitch; additional applications are available from the Module, Switch, Bridge, Interface, and Port menus, and many can also be accessed both from the icon menu (if you are running under a network management platform) and from the command line (if you are running in stand-alone mode). See Chapter 1, Introduction to SPMA for the 7C0x SmartSwitch, for a complete list of applications available to the 7C0x SmartSwitch and how to access each one.

Clicking mouse button 1 on the Quit button closes all Hub View application windows; any open applications which can also be accessed from the command line or from the icon menu will remain open.

Using the Mouse in a Hub View Module

Each network interface module, or NIM, installed in the 7C0x SmartSwitch hub will be displayed in the hub view; use the mouse as indicated in the illustration below to access Module, Switch/Bridge/Interface, and Port menus and functions.

Note that slots 3 and 4 of the 7C04-R chassis can accept either the double-wide NIM

TIP modules or the standard-size modules; both module types display as the same size in the Hub View.

2-4 Using the Hub View