Loading Paper

This section describes how to load plain paper in the multi-purpose tray so that you can begin using your MultiPASS C70. For complete details on print media specifications and other guidelines for selecting and loading print media, refer to Chapter 5, Paper Handling.

Paper Guidelines

❏To avoid paper jams and poor print quality, never try to print on damp, curled, wrinkled, or torn paper.

❏Store paper and other media flat, and leave it in its wrapper until you are ready to use it. Store unused paper from opened packs in the original packing in a cool, dry location.

❏Store paper at 18°–24°C, 40%–60% relative humidity.

❏Let the paper run out before you refill the multi-purpose tray. Avoid mixing “new” paper with paper remaining in the multi-purpose tray.

❏Use cut-sheet paper only, not paper that comes on a roll.

❏Do not use paper that is thicker than that specified for the MultiPASS C70. Printing with paper that is thick enough to come in contact with the print head nozzles may damage the BJ cartridge. For complete paper specifications, refer to Chapter 5, Paper Handling.

❏If your printed page contains a large amount of graphics, the ink on the page may be damp due to the print density. Leave the page in the output tray for 30 to 60 seconds to allow the ink to dry. Then remove the page being careful not to touch the document tray or extension. Should you dirty the document tray or extension when removing the page, wipe them clean with a clean, soft, lint-free cloth moistened with water or diluted dishwashing detergent solution.

Setting Up Your MultiPASS C70

Chapter 2

Setting Up Your MultiPASS C70

2-39