Start / Scan
n
❑If you are sending in color to a fax machine with color capability, press Color/B&W to turn on its light (see page
❑If necessary, you can adjust the resolution and contrast (see page
❑You may not be able to use memory sending if the percentage shown in the MEMORY USED display is close to 100%. In this case, use manual sending to send your document.
3.Dial the other party’s fax number.
❑Use one of the dialing methods described earlier in this chapter.
Ex:
TEL= 9p7654321
❑If you enter the wrong number, press Stop, then enter the correct number.
❑If you must first dial a digit to get an outside line (9 for example), add a pause after that digit by pressing Redial/Pause, as shown in the example above.
4.Press Start/Scan to begin scanning for sending.
❑ If you used speed dialing to dial the number, the unit will automatically begin scanning the document into memory a few seconds after making the entry.
❑You will see a series of brief messages showing details on the transmission.
❑To cancel the transmission once the unit has started to dial, press Stop. The LCD display then asks you to confirm canceling. Press T to cancel sending (see page
●You can scan up to 30 different documents for memory sending.
●When the document is sent, it is automatically deleted from memory.
●If an error occurs during sending, the MultiPASS will print out an error report. If this happens, try sending the document again.
●When an error occurs during sending, the document is automatically deleted from memory, even if it is not sent completely.
●If you send a color document to a fax machine that does not support color faxing, the document will not be sent, and the LCD display will show this message: TRY AGAIN IN B/W. Try sending again in black & white.
Sending Faxes |
Chapter 4 | Sending Faxes |