Message | Action |
CHECK INK | The ink has run out (The lamp on the ink tank flashes). |
U041 | Replace the ink tank, and close the Scanning Unit (Printer Cover). |
| If printing is in progress and you want to continue printing, press the [OK] |
| with the ink tank installed. Then printing can continue under the ink out |
| condition. Replace the empty ink tank immediately after the printing. The |
| machine may be damaged if printing is continued under the ink out |
| condition. |
| Note |
| If multiple ink lamps are flashing red, check how fast they flash. Fast |
| flashing (at about one second interval) indicates the ink is empty. Slow |
| flashing (at about three second interval) indicates ink is low. For details on |
| different flashing speeds, see “Getting the Ink Level Information” on |
| |
|
|
CHECK INK | Possible causes are as follows: |
U071 | z Some ink tanks are not installed in place. |
U072 | z More than one ink tanks of the same color are installed. |
| Confirm that the ink tanks are installed in the appropriate positions. |
| |
|
|
CHECK INK | An ink tank that was once empty is installed. |
U130 | Replace the ink tank. |
| Printing under the situation may damage the Print Head. |
| Canon shall not be liable for any machine malfunction or damage caused |
| by refilled ink tanks. |
| If you want to continue printing with the refilled ink tank installed, press |
| and hold the [Stop/Reset] for at least 5 seconds, and then release it. Using |
| refilled ink tanks are memorized. |
| * This operation will release the function for detecting the remaining ink |
| level. |
|
|
CHECK INK | Possible causes are as follows: |
U140 | z The ink tank may not be installed properly (The lamp on the ink tank is |
U043 | off). |
| Install the appropriate ink tank. |
| z The ink tank may not be compatible with this machine (The lamp on the |
| ink tank is off). |
| Install the appropriate ink tank. |
| |
|
|
CHECK INK | Ink tank errors have occurred (The lamp on the ink tank is off). |
U150 | Replace the ink tank. |
| |
|
|
CHECK PAGE SIZE | The size of the page in the Auto Sheet Feeder or Cassette and that |
| specified in the page size setting are different. |
| Load the correct page size or change the page size setting. Then press |
| [OK]. |
|
|
CHECK PRINTER | An error requiring servicing might have occurred. |
| Turn OFF the machine, and unplug the power cord of the machine from |
| the power supply. After a while, plug the power cord of the machine back |
| in and turn ON the machine. If the same error occurs, contact a Canon |
| Customer Care Center. |
114 | Troubleshooting | Chapter 9 |