Cause | Action |
Inner Cover is not closed | Close the Inner Cover completely. Paper does not feed properly if the |
completely. | Inner Cover is even slightly open. |
The media type is not selected |
|
|
|
correctly in the printer driver. |
|
|
|
| On the [Main] tab of the printer driver, ensure that the [Media Type] | ||
| selected matches the paper loaded. The print surface is smudged with | ||
| some printing jobs despite being set correctly. Should this occur, on the | ||
| [Maintenance] tab, click [Custom Settings] and place a check in [Prevent | ||
| paper abrasion]. | ||
|
| ||
|
|
| |
| In the [Print] dialog box of the printer driver, select [Quality & Media] from | ||
| the | ||
| the paper loaded. Additionally, the print surface may become smudged | ||
| with some printing jobs despite being set correctly. Should this occur, | ||
| click on [Custom Settings] from the Canon IJ Printer Utility | ||
| and place a check in [Prevent paper abrasion.]. | ||
Paper is loaded incorrectly. | Load in the portrait orientation regardless of the print direction of the Auto | ||
| Sheet Feeder or Cassette. | ||
| Ensure that paper is loaded correctly. Slide the Paper Guides against the | ||
| paper stack. | ||
|
| ||
The paper stack exceeds the | The paper cannot be fed normally depending on its media type or your | ||
capacity of the Auto Sheet Feeder. | environment where the temperature and humidity are high or low. In that | ||
| case, reduce the amount of paper to half (approx. 5 mm / 0.2" in height). |
Note
If printing surface abrasion is not resolved even after taking the actions above:
Follow the procedure below to specify <PREVENT ABRASION> to <ON>.
The procedure below can also be used when printing directly from a digital camera.
1.Display <DEVICE SETTINGS>. See “Changing the Settings” on page 91.
2.Use [ ] or [ ] to select <PRINT SETTINGS>, then press [OK].
3.Use [ ] or [ ] to select <PREVENT ABRASION>, then press [OK].
4.Use [ ] or [ ] to select <ON>, then press [OK].
After finishing printing, use the same procedure to specify <PREVENT ABRASION> back to <OFF>.
Paper Curls/Ink BlotsCause | Action |
Paper being used is too thin. | Use Photo Paper Pro or other Canon specialty paper to print images that |
| have a high color saturation. See “Media Types You cannot Use” on |
| |
|
|
126 | Troubleshooting | Chapter 9 |