Error Message On Camera | Action |
No paper/Paper Error | z Load paper in either the Auto Sheet Feeder or Cassette which you have |
| selected with the [Feed Switch] on the machine, and select "Continue"* |
| in the display on your camera. |
| z The camera does not support the page size that is selected on this |
| machine. Check the print settings and select the page size that is |
| supported by the camera. |
| z Open the Paper Output Tray to resume printing. Close the Inner Cover if |
| it is open. Select "Stop" in the display on your camera to stop printing. |
Paper jam | Select "Stop" in the display on your camera to stop printing. |
| Remove the jammed paper, load new paper, and press the [OK] on the |
| machine and retry printing. |
|
|
Printer cover open | Close the Scanning Unit (Printer Cover) on the machine. |
|
|
No print head | The Print Head is defective or not installed. |
| Install a Print Head according to the Easy Setup Instructions. |
| If the Print Head has already been installed, remove the Print Head and |
| reinstall it. |
| If the error still remains, the Print Head may be defective. Contact the |
| Canon Customer Care Center. |
|
|
Waste tank (ink absorber) full | This error message indicates that the waste ink absorber is nearly full. |
| The machine has a |
| Print Head cleaning, for example. You can continue printing by selecting |
| "Continue"* on the display on your camera. |
| However, because printing is disabled once the waste ink absorber |
| becomes completely full and until the waste ink absorber is replaced, you |
| are recommended to contact the Canon Customer Care Center as early as |
| possible. You will need to replace a particular part of the machine. |
|
|
Low ink level | Slow flashing (about three seconds in red) of an ink lamp indicates that ink |
| in this tank is low. Prepare a new ink tank. |
| Select "Continue"* in the display on your camera to resume printing. |
|
|
134 | Troubleshooting | Chapter 9 |