FAX ONLY MODE:

See “If You Want to Receive Only Faxes Automatically with Your

 

Machine, or You Have a Dedicated Telephone Line for Fax Use

 

Only:” on page 80.

MANUAL MODE:

See “If You Receive Mainly Voice Calls and Sometimes Faxes, or

 

You Want to Receive Faxes Manually:” on page 80.

ANS.MACHINE MODE:

See “If You Want to Receive Voice Messages on Your Answering

 

Machine and Receive Faxes Automatically:” on page 81.

FAX/TEL AUTO SW:

See “If You Want to Receive Faxes Automatically as well as Voice

 

Calls:” on page 81.

DRPD:

See “If You Have Subscribed to a Distinctive Ring Pattern

 

Detection (DRPD) Service with Your Telephone Company (US and

 

Canada only):” on page 82.

NETWORK SWITCH:

See “If You Want Your Machine to Automatically Switch between

 

Fax and Voice Calls by the Call Ring Patterns (Network Switch)

 

(This setting is not available in some countries and regions.):” on

 

page 82.

4 Press [OK].

The receive mode will be displayed on the bottom left of the LCD.

02/15/2006 WED 06:11AX/TE STANDARD

(A)

(A) Receive mode

Note

For details on the receive modes, see “Receive Modes” on page 80.

„Canceling Receiving

Press [Stop/Reset] and follow any instructions on the LCD.

„Memory Receiving

If ink has run out while receiving a fax, if ink level is low, if the <SIZE> setting is incorrect, or if the <TYPE> setting is other than <PLAIN>, the fax is automatically stored in memory and <RECEIVED IN MEMORY> is displayed. When the ink tank is replaced or the paper size setting is corrected, the stored fax is printed automatically.

Note

zThe machine can store up to approximately 150 pages* of faxes in memory.

zIf the memory becomes full, the machine cannot receive the remaining faxes. Print or delete the documents stored in memory (see “Printing or Deleting a Document in Memory” on page 77), and then contact the sender and have him/her resend them.

*When using ITU-T No.1 chart (Standard mode)

Chapter 4

Faxing

83