Creating a New Program
Pausing Program Execution
You can specify where execution of a program should pause by including either a Pause command or a Wait command inside the program.
kUsing the Pause Command
A Pause command causes program execution to pause when it reaches that point. To
resume program execution, tap the 
button on the right side of the status bar (which will also cause the button to disappear).
Example
kUsing the Wait Command
The syntax of the Wait command is: Wait<seconds>. When program execution reaches the Wait command, it pauses for the specified number of seconds and then resumes automatically. If you do not specify a value for the number of seconds, execution remains paused until you tap the screen or press a key.
Tip
•To input the Pause or Wait command, tap [Ctrl] on the menu bar, tap [Control], and then select the command you want.
Terminating Program Execution
Pressing cwhile a program is running terminates the program.
Tip
•Pressing cdoes not terminate the program if program execution is already paused by the
Pause command (indicated by 
on the status bar). In this case, tap 
to resume program execution, and then press c.
20050501