Debugging a Program
(7)After saving the program, tap ), or tap Oand then [Program Loader] to display the Program Loader window.
(8)On the dialog box that appears, tap the [Name] down arrow button, and then tap the name of the file you input in step (6) (TETRA).
(9)Tap p, or tap [Run] and then [Run Program].
• This runs the program.
(10)Input 7 for the length of side A and tap [OK] twice.
7 [OK] [OK]
(11)Repeat steps (9) and (10) for sides of length 10 and 15. p10 [OK] [OK]
p15 [OK] [OK]
Tip
•To edit a program and save it without running it, perform the above procedure up to step (7), and then tap [Edit] and then [Close File]. If the “WARNING! Save changes?” dialog box appears, perform one of the operations described below.
To do this: | Tap this button: |
Save and close the program | Yes |
Close the program without saving | No |
|
|
Return to the Program Editor window without saving the program | Cancel |
|
|
Tapping [Yes] or [No] causes the message “No File” to appear on the display.
20050501