Configuring Communication Parameters
u Speed (3Pin)
To specify this data rate for | Select this setting: |
9600 bps | 9600 bps |
38400 bps | 38400 bps |
115200 bps | 115200 bps* |
|
|
The above setting specifies the data rate when connected to another ClassPad, or a Data Analyzer. Note that you must set the data rate (baud rate) for both the ClassPad and the connected device so they are identical.
u Wakeup Enable
To do this: | Select this setting: |
Turn on the wakeup function (see below) | On* |
Turn off the wakeup function | Off |
(4)When all the settings are the way you want, tap [Set] to save them.
•The Communication application window appears at this time, with the new
parameters you just configured. Check to make sure the settings are the way you want.
Tip
•For more information about the communication parameter, see “Communication Dialog Box” on page
Wakeup
Wakeup is a function that automatically puts the ClassPad into data communication standby whenever the ClassPad detects data coming in from a connected external device, or when a USB cable is attached to the ClassPad. You can turn wakeup on or off with the [Wakeup Enable] setting on the Communication dialog box described on
What happens when wakeup is turned on depends on the type of device connected to the ClassPad.
kWhen connected to another ClassPad unit
When the sending device performs a data send operation, the receiver device’s wakeup function activates and data receive is performed automatically. The receiver device operates normally as long as no data is being received.
In this configuration, wakeup does not operate on the receiver device when any one of the following three conditions exists.
•When any setting other than “3pin cable” is selected for [Cable Type] on the Communication dialog box.
•When any ongoing calculation or graphing operation is being performed. Wakeup activates when the ongoing operation is complete.
•When the ClassPad is completely powered down. For details, see
20050501