16-4-6

Transferring Data to Another ClassPad Unit

Communication Standby

The ClassPad enters “communication standby” when you perform a send or receive operation. While in communication standby, the ClassPad waits for the other unit to send data, or for it to get ready to receive data.

The following describes how communication standby affects certain ClassPad operations.

•Auto Power Off (page 15-6-1) becomes disabled.

•ClassPad power cannot be turned off.

•If data communication does not start within three minutes after the ClassPad enters data communication standby, the message “Timeout” appears. When this happens, tap [Retry] to try again or [Cancel] to cancel the data communication operation.

Interrupting an Ongoing Data Communication Operation

Pressing the ckey on either the sending device or receiving device during a data communication operation terminates it.

20050501