16-4-1

Transferring Data to Another ClassPad Unit

16-4 Transferring Data to Another ClassPad Unit

This section details the steps you should perform in order to transfer data from one ClassPad unit to another.

u ClassPad Operation

(1)Use the procedure under “Connecting to Another ClassPad Unit” on page 16-2-1 to connect the two units.

(2)Use the procedure under “16-3 Configuring Communication Parameters” to configure the parameters of the two units as shown below.

Cable Type: 3pin cable

Speed (3Pin): 115200 bps

Wakeup Enable: On

•If the speed settings of the two ClassPad units are different from each other, the slower setting is used.

The remaining steps of this procedure are marked Sender to indicate steps and information that apply to the sending device, or Receiver to indicate receiving device steps and information.

Sender

(3)In the Communication application, tap [Link], and then [Transmit], or tap E.

•This displays the Select Data dialog box.

Sender

(4)Select the data you want to send.

•For more information, see “Selecting Data for Transfer” on page 16-4-3.

Sender

(5) Tap [OK].

20050501