Cisco Systems 6500 Chassis with horizontal slots, Insert module Between slot guides EMI gasket

Chapter 3 Installing Ethernet Switching Modules

Installing an Ethernet Switching Module

Step 10 Depending on the orientation of the slots in the chassis (horizontal or vertical), perform one of the following two sets of steps:

Chassis with horizontal slots

a.Position the new module in the slot. (See Figure 3-1.) Make sure that you align the sides of the module carrier with the slot guides on each side of the chassis slot.

b.Carefully slide the module into the slot until the EMI gasket along the top edge of the module makes contact with the module or cover plate in the slot above it and the module ejector levers have both closed to approximately 45 degrees with respect to the module faceplate. (See Figure 3-2.)

Figure 3-1 Positioning the Module in a Horizontal Slot Chassis

Insert module
between slot guides		EMI gasket
	3
4	4
5	5

66

WS-X6K-SUP2-2GE
1		Switch	Load
		100%
CONSOLE			PORT 1
PORT				PORT 2
MODE
CONSOLE
SUPERVISOR2	PCMCIA	EJECT
		1%
WS-X6K-SUP2-2GE
2		Switch	Load
		100%
CONSOLE			PORT 1
PORT				PORT 2
MODE
CONSOLE
SUPERVISOR2	PCMCIA	EJECT
		1%

3

4

FAN

STATUS 5

WS-X6224

24 PORT 100FX

EMI gasket		o		o
		INPUT FAN OUTPUT
		OK	OK	FAIL
				INPUT FAN OUTPUT
				FAIL
WS-C6500-SFM
	S	E
	TU
	A	TIV
T		C
S		A

58569

SWITCH FABRIC MDL

Ejector lever fully extended

Catalyst 6500 Series Ethernet Modules Installation Guide

3-4 OL-6265-04