Chapter 3 Installing Ethernet Switching Modules
What To Do After Installing Modules and Verifying Connectivity
Port | Send FlowControl | Receive FlowControl | RxPause | TxPause |
| |||
| admin | oper | admin | oper |
|
|
| |
| ||||||||
1/1 | desired | on | off | off |
| 0 | 0 |
|
Port | Status | Channel | Admin Ch |
| Neighbor |
|
| Neighbor |
|
| Mode | Group Id |
| Device |
|
| Port |
1/1 | connected | auto | 123 0 |
|
|
|
|
|
Port |
| UnderSize |
|
| ||||
|
| |||||||
1/1 | 0 | 0 |
| 0 | 0 | 0 |
|
|
Port | Runts | Giants | ||||||
1/1 | 0 | 0 |
| 0 | 0 | 23 | 0 | 0 |
Fri March 2 2003, 20:41:52 Console>
Checking Connectivity
To check connectivity on any switching module port, perform these tasks:
Task | Command |
|
|
Ping a host. | ping host |
|
|
If the host is unresponsive, check the IP | show interface |
address of the switch and default IP route, | show ip route |
if appropriate. |
|
|
|
For example, to ping a host named server1, enter this command:
Console> ping server1
server1 is alive Console>
What To Do After Installing Modules and Verifying Connectivity
After you verify the switching module installation and check connectivity, you must configure the module. For complete information on configuring the modules, see the Catalyst 6500 Series Switch Software Configuration Guide or the Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide. For information on all Catalyst 6500 series switch commands, see the Catalyst 6500 Series Switch Command Reference or the Catalyst 6500 Series Switch Cisco IOS Command Reference publications.
Catalyst 6500 Series Ethernet Modules Installation Guide
|
| ||
|
|
