Cisco Systems 6500 manual Through factory advance replacement only the Ieee 802.3af

Chapter 2 Ethernet Switching Modules

10/100 and 10/100/1000 Ethernet Modules

Table 2-13	WS-X6148-RJ-21 Ethernet Modules Features (continued)
Feature		Description
Chassis/slot restrictions		No chassis or slot restrictions; the module can occupy any slot in any
		Catalyst 6500 or Catalyst 6500-E chassis (all variants).
Bus connection		Single connection into the 32-Gbps shared bus (all variants)
Daughter card support
PoE support		WS-X6148-RJ-21—Field upgradeable to Cisco Prestandard only by
		installing the WS-F6K-VPWR= daughter card.
		Refer to the Cisco Catalyst 6500 Series Power over Ethernet Daughter
		Cards Field-Upgrade Installation Note for field upgrade procedures.
		Note An IEEE 802.3af standard PoE daughter card is available
		through factory advance replacement only; the IEEE 802.3af
		standard PoE daughter card is not field upgradeable.
Distributed forwarding		Not available.
support
Pluggable transceivers		Not supported.
support
TDR support		All variants supported.
Module front panel LEDs		STATUS
		• Green—All diagnostics pass; the module is operational.
		• Orange—The module is booting or running diagnostics; an
		overtemperature condition has occurred.
		LINK
		• Green—The port is active (the link is connected and operational).
		• Flashing orange—The port failed diagnostics and is disabled.
		• Orange—The port is disabled.
		• Red—The module is resetting; an overtemperature condition has
		occurred.
		Note If the module fails to download code and configuration
		information successfully during the initial reset, the LED stays
		red; the module does not come online.
		• Off—The port is not active or the link is not connected.
		PHONE
		• Green—The PoE daughter card is installed and detected.
		• Off—The PoE daughter card is not detected or is not installed.

Catalyst 6500 Series Ethernet Modules Installation Guide

OL-6265-04 2-21