2-79
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter2 Illustrated Card List for MGX Switches and the MGX 8880 Med ia Gateway
Front Cards
Table 2 -33 describes the LEDs on the VISM-PRs.
Module Configurations
The VISM-PR supports the following module configurations:
•Standalone.
•1:N card set redundancy, without bulk distribution
•1:N card set redundancy, with bulk distribution—For line redundancy to be supported in this
configuration, there must be redundant PXM1Es and redundant SRME cards. The APS connector
must be installed between the SRME cards.
•Bulk distribution.
Note For module configuration information, refer to Chapter 4, “Planning for Card Re dundancy, Line
Redundancy, and Bulk Distribution”.
Table2-33 VISM-PR LEDs
LED Status Description
ACT Green The VISM-PR card set (front card and back card) is in active state.
STBY Yellow or
blinking yellow
One of the following conditions exists:
•The VISM-PR is in Standby mode.
•The VISM-PR is in mismatch state.
•The VISM-PR DSPs are currently involved in the VISM-PR
bootup process.
FAIL Red When this LED is solid red and the ACT and STBY LEDs are off, one
of the following conditions exists:
•The module is in Reset mode.
•The module has failed.
•The card set is not complete (no back card).
PORT 1
through
PORT 8
Green The port is active with no alarms detected.
Red The port is active and a local alarm has been detected (LOS, LOF, or
AIS).
Note LOS is loss of signal; LOF is loss of frame; AIS is alarm
indication signal.
Yellow The port is active and a remote alarm has been detected.
Off The port is not configured, or the card set is configured as a redundant
card set and is in Standby mode.