5-92
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8950 Switch
Figure5-59 AC Power Supply Tray Cable (International)
Step2 Twist the plug clockwise to secure.
Step3 Loosen the nut on the black strain relief clamp and then slide the metal housing over the plug.
Step4 Insert the metal tabs (located on both sides of the housing) into the slots found on either side of housing
into receptacle and then push down on the housing to secure it.
Step5 Tighten the thumbscrew at the top of the housing by hand.
Step6 Tighten the nut on the strain relief to secure the cable to the housing.
Step7 Insert the other end of the cable into the wall outlet.
Step8 If you are using a secondary (redundant) power supply, repeat Step 1 through Step 7 for th e other
AC power cab le.
Figure 5-60 shows the AC power connections from the back of th e switch.
AC IN
AC IN
DC OUT
48455
To outlet
Slots
Captive
screw
Strain-relief nut Tabs