3-67
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter3 Preparing for Installation
Site Requirements for the MGX 8880 Media Gateway
Required Tools and Equipment
Table 3 -29 lists the tools and eq uipment that you need to install and remove MGX 8880 Media Gateway
components.
Note For additional cabling requirements, see AppendixB, “Cable Specifications.”
Table3-29 MGX 8880 Media Gateway Required Tools and Equipment
Check Tools and Equipment
Hardware Components and Cables
MGX 8880 Media Gateway, with the front cards and back cards installed
If your configuration was not installed in a Cisco-supplied cabinet, you will need the
following components for your system:
•Cabinet or rack that meets the RETMA Standard EIA-310-D requirements.
Note Note that three MGX 8880 DC gateways fit in a seven-foot rack.
•Air intake plenum (3.5 inches, 2 RU)
•Exhaust plenum/fan tray (these are combined for the MGX 8880 in a 3.5 inch, 2RU
unit)
•Optional for AC-powered system: AC power supply tray with power supplies
•DC PEM—for DC-powered systems
Blank front card faceplates, as needed:
•Single-height service module: Cisco Part Number SINGLE SM-CVR
•SRME: Cisco Part Number SRM-CVR
•Double-height service module: Cisco Part Number DOUBLE SM-CVR
•PXM45 or PXM1E: Cisco Part Number PROCESSOR CVR
Back card blank faceplates, as needed:
•For single-height back cards: Cisco Part Number 800-215911-00.
Warning
Blank faceplates and cover panels serve three important functions: they
prevent exposure to hazardous voltages and currents inside the chassis; they
contain electromagnetic interference (EMI) that might disrupt other equipment;
and they direct the flow of cooling air through the chassis. Do not operate the
system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Mounting kit option for 23-inch rack: Cisco Part Number MGX-MNT23
Cable management assembly: Cisco Part Number MGX-CAB-MGMT
Switch earthing conductor—Minimum of 6 AWG stranded copper wire, rated at minimum
90°C
APS connector, as necessary—Cisco Part Number MGX-8850-APS-CON or
MGX-APS-CON