5-82
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8950 Switch
Perform the following procedure to install the interconnect connections for an AC-Powered
Cisco MGX 8950 switch with a redundant AC power supply:
Caution Do NOT use power tools for this procedure.
Step1 Insert the connector labeled “Card Cage A1” into the card cage receptacle labeled “PSA 1.”
Step2 Push the connector in to seat it.
Step3 Tighten the captive screws firmly by hand.
Step4 Insert the other end of the cable labeled “PS Tray 1 J1” into the primary (top) AC power tray receptacle
labeled “J1.”
Step5 Push the connector in to seat it.
Step6 Tighten the captive screws firmly by hand.
Step7 Insert the connector labeled “Card Cage B1” into the card cage receptacle labeled “PSB 1.”
Push the connector in to seat it.
Step8 Tighten the captive screws firmly by hand.
Step9 Insert the other end of the cable labeled “PS Tray 2 J1” into the secondary (bottom) AC power tray
receptacle labeled “J1.”
Step10 Tighten the captive screws firmly by hand.
Step11 Insert the connector labeled “Card Cage B2” into the card cage receptacle labeled “PSB 2.”
Push the connector in to seat it.
Step12 Tighten the captive screws firmly by hand.
Step13 Insert the other end of the cable labeled “PS Tray 2 J2” into the secondary AC power tray receptacle
labeled “J2.”
Push the connector in to seat it.
Step14 Tighten the captive screws firmly by hand.
Step15 Insert the connector labeled “Card Cage A2” into the card cage receptacle labeled “PSA 2.”
Push the connector in to seat it.
Step16 Tighten the captive screws firmly by hand.
Step17 Insert t he other end of the cable labeled “PS Tray 1 J2” i nto the primary AC power tray receptacle labeled
“J2.”