Cisco Systems MGX 8800, MGX 8900 5-97, section on page 5-133., For further information about server management and configuration setup, refer to the appropriate , empty slot is covered by a blank faceplate.

5-97
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8950 Switch
Connect the LAN 1 port on the PXM-UI-S3 or PXM-UI-S3/B to a hub or router. This hub or router is
connected to a workstation, as shown in Figure5-64.
Figure5-64 Ethernet Connection to the LAN 1 Port
Note The LAN 2 port in Figure5-64 is not enabled.
For further information about server management and configuration setup, refer to the appropriate
software configuration guide for your switch and your release.
Verify EMI Compliance
Warning Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement 1029
Step1 If your switch has an (optional) front door, verify that the door is inst alled and closed and that each
empty slot is covered by a blank faceplate.
Step2 Install the ferrite bead if needed. Refer to “Installing the Ferrite Bead on the PXM-UI-S3/B Card”
section on page 5-133.
PXM
UI-S3
C
P
M
P
A
L
1
N
L
2
N
A
L
A
A
R
M
E
X
T
C
L
K
1
E
X
T
C
L
K
2
44372
Workstation
Hub or router
Ethernet cable
PXM-UI-S3
back card