5-38
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8850 (PXM1E/PXM45) Switch, MGX 8850/B or MGX 8880 Media Gateway
Figure5-21 AC Power Supply Tray Cable
Step2 Use both hands to slip the connector frame through the first (source A ) or third (source B) access opening
at the bottom rear of the card cage. Move the connector straight toward the backplane so that you can
guide it through the opening. Be sure that the D-connector is fully inserted in the backplane connector
and that the captive screws on the connector frame are clearly aligned w ith the threaded holes on the
chassis.
Step3 Tighten the captive screws enough to secure the connector frame flush to the chassis. Do not overtighten
the screws or use a power screwdriver.
Step4 Plug the D-connector at the other end of the cable into the first or second connector on the back of the
AC power supply tray and tighten the captive screws enough to secure the connector. Do not overtighten
the screws or use a power screwdriver. Figure 5-22 shows the AC power supply tray power cabling.
38132
Connector frameTo backplane
To AC power
tray