5-79
Cisco MGX 8800/8900 Series Hardware Installation Guide
Releases 2 - 5.2, Part Number OL-4545-01, Rev. H0, May 2006
Chapter5 Installing the Cisco MGX Switch or Gateway
Installing the MGX 8950 Switch
Figure5-46 Fan Power Cable
Complete the following steps to connect the fan power cabling:
Step1 Insert the male connector of the upper fan tray power cable (46-inch) into the connector receptacle
(labeled F1) located at the bottom of the card cage, and push the connector in to seat it.
Step2 Insert the connector at the other end of the cable into the upper fan tray receptacle as shown in
Figure 5-47, and push the connector in to seat it.
Step3 Tighten the captive screws on the connectors. Do not use a power tool.
Step4 Insert the male connector of the lower fan tray power cable (12-inch) into the connector receptacle
(labeled F2) located at the bottom of the card cage, and push the connector in to secure it.
Step5 Insert the connector at the other end of the cable into the lower fan tray receptacle as shown in
Figure 5-47, and push the connector in to secure it.
Step6 Tighten the captive screws on the connector. Do not use a power tool.
43983
To card cage To fan tray