Introduction
Accessing the Command Line Interface
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 22
1
The Command Line Interface (CLI) can be accessed from a terminal or computer
by performing one of the following tasks:
•Running a terminal application, such as HyperTerminal, on a computer that is
directly connected to the Switch’s console port,
—or—
•Running a telnet session from a command prompt on a computer with a
network connection to the Switch.
If access is via a telnet connection, ensure that the following conditions are met
before using CLI commands:
•The Switch has a defined IP address.
•Corresponding management access is granted.
•The workstation used to access the Switch is connected to the Switch.
Using HyperTerminal over the Console Interface
NOTE When using HyperTerminal with Microsoft® Windows® 2000, ensure that
Windows® 2000 Service Pack 2 or later is installed on your computer. The arrow
keys will not function properly using HyperTerminal’s VT100 emulation in
Windows® 2000 prior to Service Pack 2. For information on Windows® 2000
service packs, go to www.microsoft.com.
The Switch’s RS-232 serial console port provides a direct connection to a
computer’s serial port using a standard DB-9 null-modem or crossover cable.
Once the computer and Switch are connected, run a terminal application such as
HyperTerminal to access the Command Line Interface.
To access the Command Line Interface using the HyperTerminal application,
perform the following steps:
STEP1 Click the Start button.
STEP 2 Select All Programs > Accessories > Communications > HyperTerminal.