802.1x Commands
dot1x single-host-violation
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 538
36
User Guidelines
•User-based VLAN assignment is supported only in 802.1x multiple
sessions.
•The configuration of the parameter is allowed only when the port is Forced
Authorized or Forced Unauthorized.
dot1x single-host-violation
The dot1x single-host-violation Interface Configuration (Ethernet) mode command
configures the action to be taken when a station whose MAC address is not the
supplicant MAC address attempts to access the interface. Use the no form of this
command to restore the default configuration.
Syntax
dot1x single-host-violation {forward | discard | discard-shutdown} [trap
seconds
]
o dot1x single-host-violation
Parameters
•forward — Specifies that each station should be 802.1x authenticated. This
mode is also called ‘multiple sessions’.
•discard — Discards frames with source addresses that are not the
supplicant address.
•discard-shutdown — Discards frames with source addresses that are not
the supplicant address. The port is also shut down.
•trap
seconds—
Indicates that SNMP traps are sent. Specifies the minimum
amount of time in seconds between consecutive traps. (Range: 1- 1000000)
Default Configuration
Frames with source addresses that are not the supplicant address are discarded.
No Traps.