802.1x Commands
dot1x mac-authentication
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 544
36
Console# configure
Console(config)# interface ethernet e1
Console(config-if)# dot1x guest-vlan enable
dot1x mac-authentication
The mac-authentication Interface Configuration mode command enables
authentication based on the station’s MAC address. Use the no form of this
command to disable MAC authentication.
Syntax
dot1x mac-authentication {mac-only | mac-and-802.1x}
no dot1x mac-authentication
Parameters
•mac-only — Enable authentication based on the station’s MAC address
only. 802.1X frames are ignored.
•mac-and-802.1x —Enable 802.1X authentication and MAC address
authentication on the interface.
Default Configuration
The default configuration is disabled.
Command Mode
Interface configuration (Ethernet)
User Guidelines
Guest VLAN must be enabled, when MAC authentication is enabled.
Static MAC addresses can’t be authorized. Do not change authenticated MAC
address to static address.