SNMP Commands
snmp-server engineID local
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 346
26
The snmp-server engineID local Global Configuration mode command specifies
the Simple Network Management Protocol (SNMP) engineID on the local device.
Use the no form of this command to remove the configured engine ID.
Syntax
snmp-server engineID local {
engineid-string
| default}
no snmp-server engineID local
Parameters
•
engineid-string —
Specifies a character string that identifies the engine ID.
(Range: 5-32 characters)
•default — The engine ID is created automatically based on the device MAC
address.
Default Configuration
The engine ID is not configured.
If SNMPv3 is enabled using this command, and the default is specified, the default
engine ID is defined per standard as:
•First 4 octets — first bit = 1, the rest is IANA Enterprise number = 674.
•Fifth octet — se t to 3 to indicate the MAC address tha t follows.
•Last 6 octets — MAC address of the device.
Command Mode
Global Configuration mode