ACL Command s
permit (ip)
SPS208G/SPS224G4/SPS2024 Command Line Interface Reference Guide 51
3
•dscp — Indicates matching the
dscp-number
with the packet dscp value.
(Range: 0-63)
•ip-precedence — Indicates matching the
ip-precedence
number with the
packet ip-precedence value. (Range: 0-7)
•
icmp-type
— Specifies an ICMP message type for filtering ICMP packets.
Enter a value or one of the following values: echo-reply, destination-
unreachable, source-quench, redirect, alternate-host-address,
echorequest, router-advertisement, router-solicitation, time-exceeded,
parameter-problem, timestamp, timestamp-reply,information-request,
information-reply, address-mask-request,address-mask-reply, traceroute,
datagram-conversion-error,mobile-host-redirect, ipv6-where-are-you, ipv6-
i-am-here,mobile-registration-request, mobile-registration-reply, domain-
name-request,domain-name-reply, skip and photuris. (Range: 0-255)
•
icmp-code
— Specifies an ICMP message code for filtering ICMP packets.
ICMP packets that are filtered by ICMP message type can also be filtered
by the ICMP message code. (Range: 0-255)
•
igmp-type
— IGMP packets can be filtered by IGMP message type. Enter a
number or one of the following values: dvmrp, host-query, host-report, im or
trace. (Range: 0-255)
•
destination-port
— Specifies the UDP/TCP destination port. (Range: 0-
65535)
•
source-port
— Specifies the UDP/TCP source port. (Range: 0-65535)
•list-of-flags — Specifies a list of TCP flags that can be triggered. If a flag is
set, it is prefixed by “+”. If a flag is not set, it is prefixed by “-”. The possible
values are: +urg, +ack, +psh, +rst, +syn, +fin, -urg, -ack, -psh, -rst, -syn and -
(any IP protocol) any (25504)
EIGRP routing protocol eigrp 88
Open Shortest Path Protocol ospf 89
IP-within-IP Encapsulation Protocol ipip 94
Protocol Independent Multicast pim 103
Layer Two Tunneling Protocol l2tp 115
ISIS over IPv4 isis 124
IP Protocol Abbreviated
Name
Protocol
Number