Cisco Systems WSC2960X48TDL voice voice-signaling vlan vlan-id cos, dscp dvalue none untagged

Configuring LLDP, LLDP-MED, and Wired Location Service

Configuring Network-Policy TLV

	Command or Action
Step 3	{voice voice-signaling}vlan [vlan-id{cos
	cvalue dscp dvalue}] [[dot1p {cos cvalue
	dscp dvalue}] none untagged]
	Example:
	Switch(config-network-policy)# voice vlan
	100 cos 4

Step 4 exit

Example:

Switch(config)# exit

Purpose

Configures the policy attributes:

•voice—Specifies the voice application type.

•voice-signaling—Specifies the voice-signaling application type.

•vlan—Specifies the native VLAN for voice traffic.

•vlan-id—(Optional) Specifies the VLAN for voice traffic. The range is 1 to 4094.

•cos cvalue—(Optional) Specifies the Layer 2 priority class of service (CoS) for the configured VLAN. The range is 0 to 7; the default is 5.

•dscp dvalue—(Optional) Specifies the differentiated services code point (DSCP) value for the configured VLAN. The range is 0 to 63; the default is 46.

•dot1p—(Optional) Configures the telephone to use IEEE 802.1p priority tagging and use VLAN 0 (the native VLAN).

•none—(Optional) Do not instruct the IP telephone about the voice VLAN. The telephone uses the configuration from the telephone key pad.

•untagged—(Optional) Configures the telephone to send untagged voice traffic. This is the default for the telephone.

•untagged—(Optional) Configures the telephone to send untagged voice traffic. This is the default for the telephone.

Returns to global configuration mode.

Step 5	interface interface-id	Specifies the interface on which you are configuring a network-policy
		profile, and enter interface configuration mode.
	Example:
	Switch (config)# interface
	gigabitethernet2/0/1
Step 6	network-policy profile number	Specifies the network-policy profile number.
	Example:
	Switch(config-if)# network-policy 1

	Catalyst 2960-X Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX
62	OL-29034-01