Starting the setup wizard
•Select Easy Setup Wizard (the button in the upper right corner of the
•Use the information that you gathered in Transparent mode settings to fill in the wizard fields. Select the Next button to step through the wizard pages.
•Confirm your configuration settings and then select Finish and Close.
Reconnecting to the web-based manager
If you changed the IP address of the management interface while you were using the setup wizard, you must reconnect to the
Using the command line interface
As an alternative to the setup wizard, you can configure the
Changing to Transparent mode
•Log into the CLI if you are not already logged in.
•Switch to Transparent mode. Enter: set system opmode transparent
After a few seconds, the following prompt appears:
•Type admin and press Enter. The following prompt appears:
Type ? for a list of commands.
•Confirm that the
The CLI displays the status of the
Configuring the Transparent mode management IP address
•Log into the CLI if you are not already logged in.
•Set the IP address and netmask of the Management IP to the IP address and netmask that you recorded in Transparent mode settings. Enter:
set system management ip <IP address> <netmask>
Example
set system management ip 10.10.10.2 255.255.255.0
•Confirm that the address is correct. Enter: get system management
20 | |
|